Garage Door Opener Repair in Bentley, MI

If the door lifts easily by hand after pulling the release cord, the problem is inside the opener, usually a stripped plastic drive gear. That is an inexpensive, very common repair. If the door is heavy to lift by hand, the opener is fine and you have a broken spring, in which case running the opener again risks damaging it.

It depends on the part and the age. Sensors, gear kits, remotes and limit switches are cheap and worth fixing at almost any age. A failed logic board on a unit over fifteen years old usually is not, because the replacement board costs a large fraction of a new, quieter, safer opener. We give you both numbers.

Intermittent loss is usually a weak logic board or a failing antenna wire rather than the remotes. If only one remote misbehaves, start with the battery. If all of them drop out together, and especially if the range has been shrinking, the receiver in the opener head is the likely culprit.

Most Bentley calls booked before early afternoon get a same-day slot, and anything after that is typically next morning. Emergencies such as a trapped car, a door stuck open or storm damage are prioritised and dispatched around the clock. When you call we give you a two-hour arrival window rather than a vague day.

All the common ones: LiftMaster, Chamberlain, Genie, Craftsman, Sommer, Overhead Door, Marantec and Wayne Dalton, plus commercial operators. If your unit predates 1993 it has no photo-eye safety sensors, and we will recommend replacement on safety grounds rather than repairing it.

That is the safety reversal doing its job. Either the photo-eye sensors are misaligned or obstructed, or the close-force setting on the opener is too sensitive, or something in the track is physically stopping the door. Check the sensors first: both lights should be steady, not blinking. If they look fine, it is usually a force adjustment.