Garage Door Opener Repair in Falmouth, MI

If the door lifts easily by hand after pulling the release cord, the problem is inside the opener, usually a stripped plastic drive gear. That is an inexpensive, very common repair. If the door is heavy to lift by hand, the opener is fine and you have a broken spring, in which case running the opener again risks damaging it.

It depends on the part and the age. Sensors, gear kits, remotes and limit switches are cheap and worth fixing at almost any age. A failed logic board on a unit over fifteen years old usually is not, because the replacement board costs a large fraction of a new, quieter, safer opener. We give you both numbers.

Intermittent loss is usually a weak logic board or a failing antenna wire rather than the remotes. If only one remote misbehaves, start with the battery. If all of them drop out together, and especially if the range has been shrinking, the receiver in the opener head is the likely culprit.

Nine times out of ten it is the rollers. Builder-grade steel rollers run on exposed bearings that dry out, flat-spot and then grind in the track. Swapping to sealed nylon rollers is inexpensive and makes an immediate difference. Loose hinges, a dry torsion bar and an unbalanced door also contribute.

Small repairs such as sensor realignment, a roller swap or a limit adjustment are usually the minimum service charge. A torsion spring replacement on a standard double door is the most common job and sits in the low hundreds for a matched pair fitted. Opener repairs depend on whether it is a gear kit or a logic board. You get a flat number before we start, not an hourly rate.

Yes. We service rolling steel, sectional, high-speed and fire-rated doors for warehouses, body shops, fleet yards and retail units around Falmouth. We stock high-cycle springs and commercial operators, and we schedule around your hours where possible so the work happens before opening or after close.