Garage Door Opener Repair in Watton, MI

If the door lifts easily by hand after pulling the release cord, the problem is inside the opener, usually a stripped plastic drive gear. That is an inexpensive, very common repair. If the door is heavy to lift by hand, the opener is fine and you have a broken spring, in which case running the opener again risks damaging it.

It depends on the part and the age. Sensors, gear kits, remotes and limit switches are cheap and worth fixing at almost any age. A failed logic board on a unit over fifteen years old usually is not, because the replacement board costs a large fraction of a new, quieter, safer opener. We give you both numbers.

Intermittent loss is usually a weak logic board or a failing antenna wire rather than the remotes. If only one remote misbehaves, start with the battery. If all of them drop out together, and especially if the range has been shrinking, the receiver in the opener head is the likely culprit.

Small repairs such as sensor realignment, a roller swap or a limit adjustment are usually the minimum service charge. A torsion spring replacement on a standard double door is the most common job and sits in the low hundreds for a matched pair fitted. Opener repairs depend on whether it is a gear kit or a logic board. You get a flat number before we start, not an hourly rate.

That is the safety reversal doing its job. Either the photo-eye sensors are misaligned or obstructed, or the close-force setting on the opener is too sensitive, or something in the track is physically stopping the door. Check the sensors first: both lights should be steady, not blinking. If they look fine, it is usually a force adjustment.

We cover Watton and the surrounding communities, and we service all of Michigan. If you are on the edge of our usual patch, call and ask. We will tell you honestly whether we can get to you quickly or whether you are better served by someone closer.