Garage Door Spring Repair & Replacement in Walled Lake, MI

The clearest sign is a loud bang from the garage, often overnight, followed by a door that is suddenly far too heavy to lift by hand. Look at the torsion spring on the bar above the door: a broken one has a visible two to three inch gap. The opener may also hum and strain without moving the door, or move it a few inches then stop.

Yes, on a two-spring door. They are installed at the same time and wear at the same rate, so the surviving spring is typically within weeks or months of failing too. Replacing the pair costs far less than paying a second callout, and a mismatched pair puts the door out of balance.

Springs are rated in cycles, one cycle being one open and one close. A standard 10,000-cycle spring lasts roughly seven years on a door used four times a day. High-cycle springs rated at 20,000 or more cost modestly more and can double that lifespan, which is usually worth it on a door that is the main entrance to the house.

A straightforward single or double door replacement is typically a half-day: removing the old door and hardware, squaring the opening, installing the new track and spring system, then balancing and testing. Custom sizes, carriage-house doors or jobs needing structural work can run into a second visit.

That is the safety reversal doing its job. Either the photo-eye sensors are misaligned or obstructed, or the close-force setting on the opener is too sensitive, or something in the track is physically stopping the door. Check the sensors first: both lights should be steady, not blinking. If they look fine, it is usually a force adjustment.

Usually yes. Standard torsion springs for residential doors ride on the van, so most Walled Lake spring calls are completed on the first visit. Oversized, high-cycle or unusual commercial springs may need ordering, in which case we secure the door safely and return as soon as the part lands.