Burt's garage door repair and new door team

Most Burt calls booked before early afternoon get a same-day slot, and anything after that is typically next morning. Emergencies such as a trapped car, a door stuck open or storm damage are prioritised and dispatched around the clock. When you call we give you a two-hour arrival window rather than a vague day.

Nine times out of ten it is the rollers. Builder-grade steel rollers run on exposed bearings that dry out, flat-spot and then grind in the track. Swapping to sealed nylon rollers is inexpensive and makes an immediate difference. Loose hinges, a dry torsion bar and an unbalanced door also contribute.

Small repairs such as sensor realignment, a roller swap or a limit adjustment are usually the minimum service charge. A torsion spring replacement on a standard double door is the most common job and sits in the low hundreds for a matched pair fitted. Opener repairs depend on whether it is a gear kit or a logic board. You get a flat number before we start, not an hourly rate.

Yes. We service rolling steel, sectional, high-speed and fire-rated doors for warehouses, body shops, fleet yards and retail units around Burt. We stock high-cycle springs and commercial operators, and we schedule around your hours where possible so the work happens before opening or after close.

We publish the after-hours rate when you book so there is no ambush on the invoice. Many straightforward evening calls in Burt are charged at the standard rate. If a job can safely wait until morning at a lower price, we will tell you that instead of taking the premium.

A straightforward single or double door replacement is typically a half-day: removing the old door and hardware, squaring the opening, installing the new track and spring system, then balancing and testing. Custom sizes, carriage-house doors or jobs needing structural work can run into a second visit.